High-performance and high-bearing capacity snowmobile snow outdoor
tool anti-skid kit
High quality high performance high load capacity for snowmobiles
Strong support surface with rust resistant powder coating. Two
front wheel shapes available. 1500 lbs. load capacity (set) Sturdy
steel plate design, 2-3/8 inch hard rubber casters Three piece set
allows for minimal gap turns and safe control of the snowmobile in
storage areas. 1500 lbs. high load capacity, essential for winter
snowmobiles, adjustable nylon straps, rear cart with four steel
carts. Strap it to the snowmobile and you can easily start the
snowmobile. Swivel casters allow for maneuvering in tight spaces,
and sturdy adjustable nylon straps. Allows you to easily move
snowmobiles on the ground or in the garage
|Usage||Help the snowmobile to move from the garage to the snow|
|Feature||Small size, strong bearing capacity|
|Size||H Steel plate:10"*8"Flat plate:8"*8"|
|Packing Weight||15.76 LBS|
|Advantage||Portable, save storage space|
How do you tie the belt?
Answer:Pass the non-loop end of the strap through a slot on the top
edge of the cart. Then pass the non-loop end of the strap through
the loop end and tighten it. Then connect one end of the strap to
the cart. Put the snowmobile skis on the trolley. Put the strap on
the ski and pass it through another slot on the top edge of the
trolley. Pull tight and return to the top of the ski, then push the
Velcro pieces together.
Whats the best way to get your sled on this?
Each front ski one at a time first. If you pull upward on front of
ski you can slide them into place. Next place rear dooly next to
track at spot you want track to set upon it. Lift back straight up
high enough to clear rear dolly and move rear of sleds over dolly
and lower into place. Fairly simple to do.
If you have any questions about the products you have purchased,
you can consult our customer service. If you have any questions,
you are welcome to contact us online, email, or phone!